1. When replacing other new screens, the screen must be tightened before bonding, otherwise it will affect the vibration effect of the vibrating screen;
2. The connector nut of the connection line between the bottom frame and the power box must be tightened to prevent the power cord from wearing out after the nut is loose;
3. When the noise or heat in the power control box is too loud, the user should replace the fan of the same specification in the control box in time;
4. According to the specific gravity of the material to be screened, the frequency of the vibrating screen should be greatly adjusted, and the operation must be carried out according to the actual material;
5. When the vibrating screen meets the production requirements, the output power of the power control box is as small as possible;
6. Make sure that the lower end of the P-shaped grille and the grille bolts are not loose, and regularly check whether it is loose;
7. When the ultrasonic control box or sensor is out.