1. Before installing the machine, first check whether the parts are complete and damaged by referring to the packing list.
2. When installing the vibrating screen, please refer to the installation drawing for installation. The supporting frame must be installed horizontally on the foundation. The foundation should have sufficient rigidity and strength to support all the dynamic and static loads of the vibrating screen.
3. The sieve box trunnion can be used to lift the sieve machine, and the whole sieve cannot be directly hung on the vibration exciter.
4. When installing the screen, make sure to keep a minimum clearance of 80mm between the screen box and non-moving parts such as hoppers and troughs.
5. After the vibrating screen is installed, the screen surface should be kept horizontal on the left and right sides, otherwise, a thin iron sheet can be placed between the spring seat and the support for adjustment.
6. The vibrating screen spring must be in a vertical state, and the spring fixing frame is fixed on the trunnion of the screen box.
7. Ensure that the tension of the V-belt has sufficient adjustment, and the end faces of the two pulleys are adjusted in a plane.
8. The exciter must be rotated by hand (or other methods) before the test run. The machine can be started only when the rotation is flexible and there is no jamming phenomenon.
9. After the stainless steel vibrating screen is installed and adjusted, it should be tested for no less than 2 hours without load. It is required to run smoothly, without abnormal noise, and the maximum temperature of the bearing does not exceed 75°C.
10. The user can increase or decrease the number of auxiliary eccentric blocks and adjust the amplitude of the vibrating screen to achieve the ideal screening effect according to the on-site use.