In the normal use of the diaphragm filter press, we often find that the diaphragm filter press has the appearance of heat. This heat will have a certain impact on the use of the filter press. So how can we eliminate this phenomenon of overheating?
There are two reasons for the overheating of the diaphragm filter press: one is the hydraulic system, and the other is the filter plate of the filter press.
The hydraulic system of the filter press is closely related to the temperature. The temperature can be controlled by the heat release device of the hydraulic system, so that the filter press can operate normally, and the temperature of the hydraulic station should not be too high. This will affect the hydraulic system, and then cause the system to fail to operate normally. The filter plate of the filter press is made of polypropylene, which can effectively avoid overheating, slow down the increase in temperature, reduce the differentiation and oxidation of the filter plate of the filter press, and increase the service cycle of the filter plate. . Reduce the damage of the filter plate, increase the production rate, and obtain greater profits.
If the filter press is overheated, it will not only have a great impact on the operation of the staff, but also will have a certain impact on the filtrate during the operation, which will cause the filtrate to change, and then affect the separation effect, so the operation You should pay attention to the overheating of the filter press during the process.
1. If the bearing of the diaphragm filter press is found to be damaged, it must be replaced in time. When installing the new bearing, a very high standard is required, carefully and not careless.
2. Prevent intense impact to the bearing and prevent scars, indentations and cracks.
3. In the process of using the diaphragm filter press, pay attention to the anti-rust treatment of the bearing regularly, and do not make too much water stained. Clean, lubricate and maintain the periphery of the bearing seat.