After ultrasonic vibrating screen to customer site, many customers can not report the operation, improper operation can not reach the best screening effect, vibration screen manufacturers according to the reflection of the requirements of the customer detailed reading ultrasonic system user manual, the explanation of the manual is relatively detailed. After all, the ultrasonic vibrating screen system is slightly more complicated than the mechanical principle, so as not to cause unnecessary loss and unnecessary trouble in testing.
Operation method of ultrasonic vibrating screen
1, ultrasound system to use the whole set of testing, many customers reflect that the ultrasonic system after overhaul can not be used normally, The reason is that if the power box does not have any problems after factory testing, but the transducer is not checked, the transducer is broken and the power box can only be repaired according to the inability to find any problems.
2.Transmission and voltage of working power supply for ultrasonic system is 220V AC, The ultrasonic output power is connected to the transducer by the back panel of the power box, in which the red is the positive pole. Pay attention to the voltage pole and not to connect errors.
3.Can achieve sieving effect power to adjust the bottom as far as possible, maximum current should not exceed 0.4.Avoid unnecessary energy consumption and power flow unnecessary damage.
4.Do not turn on the ultrasonic system when the screen is not stretched, otherwise the power flow may occur and the transducer may be damaged.
5.The best screening effect can be achieved only by the strain of the sieve screen, otherwise the ultrasonic output and vibration effect of the screen operator will be seriously affected by the screening effect and the screening output.
6.The air plug screws above the transducer must be tightened and checked regularly for breakage of the data wire.The air connector and data cable must be wrapped with insulating tape to prevent dust. The vibration wave energy of the ultrasonic vibrating screen cannot be transmitted without tightening the air plug. it loses its vibrational effect.
7.If the material has conductivity, please keep the power box away from the material site to prevent the material from entering the power box causing short circuit.
8, hair fruit found that the noise inside the power source standard is too large or the fan does not move, please stop working immediately, check the cooling fan. Please pay attention to ventilation when the power box is used.
9, each set of ultrasound including a resonant power source, an oscillator, a grid frame. All three should be numbered together for better effect. Do not mix with other ultrasonics.