1. It is necessary to select screen with thicker wire diameter, because the installation of linear vibration screen is relatively cumbersome. When cutting, the width of screen and the net frame can be kept the same, and the length must be 50-70 mm longer than the net frame.
2. When installing, the screen must be tightened, because the tightness of the screen is an important factor affecting the screening efficiency.
4. When installing net-clearing marbles, we must pay attention to the difficulty of screening materials and the number of meshes.
5. If the proportion of material is large or the mesh number is high, the mesh number suitable bracket should be added under the linear vibration screen. The purpose is to play a supporting role, reduce the pressure of material on the screen and prolong its service life.
6. After the lattice frame is installed into the box body according to the requirement, remember to extend the long screen mesh into the corresponding outlet to avoid mixing phenomenon.
7. When installing the pressure plate, we must pay attention to its smoothness and lock it evenly with the sponge sealing belt with strong flexibility, because this is not only the key to eliminate mixing stage, but also an important factor affecting the service life of screen mesh.
8. After installing the linear vibrating screen, a small amount of material should be used to test the distribution and screening situation of the screen. If the material is evenly conveyed forward and classified accurately, and there is no mixing phenomenon, it can be put into use. On the contrary, if there are uneven phenomena such as run-off or pile-up, the smoothness and evenness of the screen surface of the screen should be adjusted.