The chamber filter press is commissioned before use to ensure safety

The chamber filter press is commissioned before use to ensure safety

The chamber filter press must be commissioned before it is put into use. For the van filter press that has been deactivated for a period of time, it can be debugged before it is put back into service. This is an important guarantee for the efficiency and safety of use. . Open all the outlet valves of the chamber filter press, close the water-washing, air-washable machine type valve, and open the feed valve for about a quarter. At this time, start the feed pump to check the filtrate and feed pressure changes, such as pressure super High, you need to open the valve on the return line to adjust. Due to the capillary action of the filter cloth of the chamber filter press, the filtrate will look turbid at the beginning of filtration, which is a normal phenomenon.

  Check whether the configuration of the pipeline, valve, valve, valve, etc. of the chamber filter press is correct and reasonable; check the power supply wiring, pay attention to waterproof and moisture proof, the layout should be safe and reasonable, and avoid the box filter press at work. When the power line is broken. Wipe the rack, filter plate and piston rod clean. The box filter press checks whether the filter plate is neat and correct. Then you should pay attention to the condition of the filter cloth and check whether the filter cloth is folded or not. If necessary, Flattening.

  Clean and check the hydraulic station, electric control box and other parts of the box filter press. These are clean first, and the inside of the fuel tank should also be cleaned. Check the power supply of the chamber filter press and whether the pressure and return oil pipes are normal. To ensure that the chamber filter press is installed correctly, check whether the upper and lower pressure limits of the electric contact pressure gauge of the chamber filter press meet the requirements.