Rotary vibrating screen is a kind of three-dimensional vibrating screen. The equipment has high screening accuracy, low noise and high efficiency. It only takes 3-5 minutes to change the screen quickly. It has a fully enclosed structure and is suitable for screening materials such as granules, powder and mucus. Sub-filtering. The screen is a vulnerable part in the accessories of the rotary vibrating screen. It will be damaged after a long time of use. If the screen is damaged, you don't have to worry about it. Just replace the screen.
The following specifically introduces the method of replacing the screen:
1. Loosen the screen grid tie-ring screws that need to be replaced, remove the upper frame, turn over the sealing rubber ring, remove the pressure mesh bar, and remove the need to replace the screen.
2. Then spread the new screen on the mother net, install the pressure net, and flatten it all around (avoid too tight) and leave one centimeter along the pressure net.
3. Reserve 2 cm of the extra fine mesh around the screen frame, and cut off all the rest.
4. Wrap with airtight leather.
5. Put the upper frame back to its original position, put the tie ring back on the screen, use a soft hammer to evenly hit the tie ring around, and then tighten the tie ring copper nut.
6. If the net frame and the punching plate are removed during the screen changing process, you must pay attention when reinstalling, the punching plate must be inserted into the groove on the bottom of the net frame.
The method of replacing the mother net:
If the mother net is damaged, you can repair it yourself, if it cannot be repaired, you can send it back to our company for repair. It is recommended that users prepare a set of mother nets (grids) for urgent needs.