The method of solving the deformation of the plate and frame filter press frame, in terms of the performance of the plate and frame filter press, the gap with similar foreign equipment is constantly narrowing. However, in the face of long-term use of plate and frame filter press may face the problem of deformation of the frame, is the correct and effective way to deal with:
To solve the problem of the frame deformation of the plate and frame filter press, first of all, see if the anchor screws of the filter are tightened. One end of the plate filter press stop plate is tightened as normal, and the screws at the bottom of the cylinder seat must not be tightened.
After the filter plate and filter cloth of the plate and frame filter press are cleaned and installed neatly, observe the direction in which the rack is tilted and bent. Align the filter plates in the direction of the stop plate. If the beam is bent to the left, leave fifteen to twenty filter plates at the bend to draw a forty-five-degree angle, press hard to the right, and press the remaining filter plates. The tight end is drained neatly. The plate and frame filter presses the start button and presses the filter plate tightly. At this time, the 45-degree angle filter plate squeezes the force to the right, pay attention to the pressure control, and relax the filter plate when it reaches the equilibrium point.