The filter press is installed and adjusted on the flat concrete.
The filter mechanism of the sand washing filter press consists of a filter plate, a filter frame, a filter cloth, and a press diaphragm. Both sides of the filter plate are covered by filter cloth. When the filter press needs to be equipped with a press diaphragm, a set of filter plates consists of a diaphragm plate and a side plate. composition. Both sides of the base plate of the diaphragm plate are covered with rubber diaphragms, and the outside of the diaphragm is wrapped with the filter plate of the side plate of the filter cloth. The membrane filter press is a filter press with an elastic membrane installed between the filter plate and the filter cloth. When the feeding is finished during operation, high-pressure fluid or gas medium can be injected into the diaphragm plate, and the filter cake can be further dehydrated, pressed and filtered.
The thrust plate at the feed end should be fixed, and the support end should be locked with two nuts after positioning. There is no anchor bolt or anchor bolt. There is a proper gap between the nut washer and the foot seat. The verticality of the large plane between the front correction beam and the thrust plate. The layout should be carried out by the construction engineer according to the configuration load, and the anchor rod should be grouted for the second time in the reserved hole position. There should be sufficient operating and maintenance space around the filter pressure.
The hydraulic filter press should choose a suitable location to arrange the hydraulic station. Filter plate, washing pipe and drain pipe. Equipped with a filtration pressure indicator and a return flow channel to control the filtration pressure. In the environment where the diaphragm is squeezed, a compressed atmosphere pipeline is installed. Hydraulic oil with low ambient temperature, similar viscosity, and low condensation point can be selected for hydraulic filter press and hydraulic station oil tank filled with clean hydraulic oil. When the hydraulic pressure is under pressure, the pressure gauge rises, and there will be no leakage in the hydraulic system. The pressure of the hydraulic station should be adjusted accurately according to the size of the model. If the storage capacity of the oil tank is not enough after the test, it must be supplemented.